Ettiene and Petri contacted us to assist with bulk head repair in Montana. They had another contractor install bulkheads but the work was sub standard.
They already had a thoughtful and modern kitchen but needed the bulk head repaired to fulfill their vision.
Due to the poor installation by the previous contractor we had to demolish the bulk head and rebuild it completely from scratch. The previous contractor also made use of brandering instead of the supplier recommended galvanized structures. Due to brandering being wood there was a lot of curving and contorting which is the last thing one needs when perfectly straight lines and square edges are needed.
It was horrifying that Ettiene and Petri had to pay again to have the bulk head redone after they trusted the contractor to do honor their expectations.
The structure was created from galvanized main tees and cross tees as per supplier recommendation. Corner sections done with galvanized angle and all secured with wafer tech screws.
It needs to be noted that accuracy when constructing the structure is of utmost importance. If the structure is poorly constructed the end product will be of poor visual quality.After the bulk head structure was completed 9.5mm Gypsum board cladding was used and corners trimmed with corner beads. Care needs to be taken that this done properly as a corner bead fitted a slight bit out of position will have a disastrous effect on the final aesthetic look.
After all of the above was completed two coats of Rhinolite was applied and skimmed to a smooth flawless finish.To ensure you don’t suffer the same horrible fate than Ettiene and Petri be sure to call the professionals to have your bulk head installed.
Don’t delay and call us today!!!
Below a link with some more information: